Weider 8510 User Manual page 12

21. Route the Short Cable (58) around the 3 1/2"
Pulley (15) attached to the lower hole in the
Front Upright (42). See the inset drawing.
Be sure that the Cable Trap (66) is turned
to hold the Cable in place and that the
Cable is routed around the Pulley as
shown. Tighten the 3/8" Nylon Locknut (21)
and the 3/8" x 3 3/4" Bolt (71).
22. Route the Short Cable (58) around the 3 1/2"
Pulley (15) attached to the upper hole in the
Press Frame (17). Be sure that the Cable
Trap (66) is turned to hold the Cable in
place and that the Cable is routed around
the Pulley as shown. Tighten the 3/8" Nylon
Locknut (21) and the 3/8" x 3 1/2" Bolt (not
shown).
23. Route the Short Cable (58) around the 3 1/2"
Pulley (15) attached to the upper hole in the
Front Upright (42). See the inset drawing.
Be sure that the Cable Trap (66) is turned
to hold the Cable in place and that the
Cable is routed around the Pulley as
shown. Tighten the 3/8" Nylon Locknut (21)
and the 3/8" x 3 3/4" Bolt (71).
12
21
42
15
42
15 71
66
58 58
Inset shows view
21
from other side
22
58
15
66
21
17
23
42
58
15
71
15
42
21 66
58
Inset shows view
from other side
24. Attach the end of the Short Cable (58) to the
Long "U"-Bracket (57) with a 1/4" Nylon Lock-
nut (2) and a 1/4" Flat Washer (10). Do not
completely tighten the Nylon Locknut. It
should be threaded onto the end of the
Cable so only a couple of threads are
showing above the nut, as shown in the
inset drawing.
25. Attach the Long Cable (23) to the Small "U"-
Bracket (67) with a 1/4" Nylon Locknut (2)
and a 1/4" Flat Washer (10). Do not com-
pletely tighten the Nylon Locknut. It
should be threaded onto the end of the
Cable only a couple of turns, as shown in
the inset drawing.
Attach the Small "U"-Bracket (67) to the
Weight Tube (63) with the 5/16" x 1 1/2" Bolt
(72) and a 5/16" Nylon Locknut (3).
13
24
2
57
10
58
2
10
57
58
25
23
67
72
3
63
10
2
23
10
2
67