7.18 Setting Record - Biasi Advance Plus 16S ERP User Manual And Installation Instructions

• Press keys 11 and 13 (Fig. 7.45) at the
same time until the value of parameter 12
(99=Advance Plus 16S ERP - Advance Plus
25S ERP - Advance Plus 30S ERP) is dis-
played on the LCD display (Fig. 7.48).
Fig. 7.48
• It is possible to modify parameter using keys
12 or 13 (Fig. 7.45) (Refer to Fig. 7.44 and
determine the correct Value appertaining to
the output required for the central heating
requirement.).
• By pressing key 11 (Fig. 7.45) confirmation
of the inserted value is obtained.
• Press keys 11 and 12(Fig. 7.45) at the same
time to exit without changing the value (re-
turn to the parameters list Fig. 7.47).
• Press keys 11 - 12 - 13 (Fig. 7.45) at the
same time for 10 seconds to exit the "pro-
gramming mode".

7.18 Setting record

Important: at the end of the setting opera-
tion it is important to fill/update the table
(Fig. 7.49).
This to allow a correct setting of this boiler
in case of replacement of the main control
p.c.b.
PARAMETER
Boiler type (to be
updated with the
complete range)
Water sensors
configuration
Pump speed
Not used
COMMISSIONING
DIGIT VALUES
Pr 01
Pr 02
Pr 03
Pr 04 ---------------
PARAMETER
Gas type
Not used
C.h. flow max tem-
perature °C
Factory param-
eters reset
Chimney sweep
function
C.h. reignition fre-
quency
C.h. pump post-
circulation
Max. useful output
in c.h. mode
C.h. pump working
type
Ignition power
K value (external
probe diagram)
Not used
Not used
NTC on the c.h.
return
LCD type
Not used
Not used
Not used
Not used
Not used
Not used
Not used
C.h. minimum set-
point
Maintenance inter-
vals
NTC inlet probe
Correct pressure
c.h. system
Fig. 7.49
DIGIT VALUES
Pr 05
Pr 06 ---------------
Pr 07
Pr 08
Pr 09
Pr 10
Pr 11
Pr 12
Pr 13
Pr 14
Pr 15
Pr 16
Pr 17 ---------------
Pr 18
Pr 19
Pr 20
---------------
Pr 21 ---------------
Pr 22 ---------------
Pr 23 ---------------
Pr 24 ---------------
Pr 25 ---------------
Pr 26 ---------------
Pr 27
Pr 28
Pr 29
Pr 30
- 65 -