Ford TOURNEO CONNECT 2015 Owner's Manual page 210

Note: If traffic announcement is on and you
select a preset or manual tune to a non
traffic announcement station no traffic
announcements will be heard.
Note: When you are listening to a non
traffic announcement station and turn
traffic announcement off and on again a TP
seek will occur.
Traffic Announcement Volume
Traffic announcements interrupt normal
broadcasts at a preset minimum level that
is usually louder than normal listening
volumes.
To adjust the preset volume:
• Use the volume control to make the
necessary adjustment during an
incoming traffic announcement
broadcast. The display will show the
level selected.
Ending Traffic Announcements
The audio unit will return to normal
operation at the end of each traffic
announcement. To end the announcement
prematurely, press TA or TRAFFIC during
the announcement.
Note: If you press TA or TRAFFIC at any
other time it will switch all announcements
off.
Automatic Volume Control
When available, automatic volume control
adjusts the volume level to compensate
for engine noise and road speed noise.
Press the MENU button.
Select
1 Audio settings
2 Adaptive volume
Tourneo Connect (CHC) Vehicles Built From: 10-03-2014, Vehicles Built Up To: 31-12-2014, Long Wheelbase Kombi/Short Wheelbase Kombi, Base/Base High Payload/Titanium/Titanium High Payl
Audio System
1. Use the left or right arrow button to
adjust the setting.
2. Press the OK button to confirm your
selection.
3. Press the MENU button to return.
News Broadcasts
The audio unit may interrupt normal
reception to broadcast news bulletins from
stations on the FM frequency band, radio
data system or other enhanced network
linked stations.
The display will indicate there is an
incoming announcement, during news
broadcasts. When the audio unit interrupts
for a news broadcast the preset volume
level will be the same as traffic
announcements.
Press the MENU button.
1
2
1. Turn on or off with the OK button.
2. Press the MENU button to return.
Alternative Frequencies
The majority of programs that broadcast
on the FM frequency band have a program
identification code, it can be recognized by
audio units.
When your vehicle moves from one
transmission area to another with the
alternative frequencies tuning switched
on, this function will search for the
strongest station signal.
Under certain conditions, however,
alternative frequencies tuning may
temporarily disrupt normal reception.
208
Select
Audio settings
News