Engine Coolant Check - Ford TOURNEO CONNECT 2015 Owner's Manual

Adding Engine Oil
WARNINGS
Only add oil when the engine is cold.
If the engine is hot, wait 10 minutes
for the engine to cool down.
Do not remove the filler cap when
the engine is running.
1. Remove the engine oil filler cap. See
At a Glance (page 12).
2. Add engine oil that meets Ford
specifications. See Technical
Specifications (page 176).
3. Replace the engine oil filler cap. Turn
it until you feel a strong resistance.
Note: Do not add oil further than the
maximum mark. Oil levels above the
maximum mark may cause engine damage.
Note: Soak up any spillage with an
absorbent cloth immediately.

ENGINE COOLANT CHECK

WARNING
Do not allow the fluid to touch your
skin or eyes. If this happens, rinse the
affected areas immediately with
plenty of water and contact your physician.
Note: Make sure that the level is between
the MIN and the MAX marks.
Note: Coolant expands when it is hot. The
level may therefore extend beyond the MAX
mark.
If the level is at the MIN mark, add coolant
immediately.
Tourneo Connect (CHC) Vehicles Built From: 10-03-2014, Vehicles Built Up To: 31-12-2014, Long Wheelbase Kombi/Short Wheelbase Kombi, Base/Base High Payload/Titanium/Titanium Hig
Maintenance
Adding Engine Coolant
Only add coolant when the engine is
cold. If the engine is hot, wait 10
minutes for the engine to cool down.
Do not remove the filler cap when
the engine is running.
Do not remove the filler cap when
the engine is hot. Wait for the engine
to cool down.
Undiluted coolant is flammable and
may ignite if spilt on a hot exhaust.
Note: In an emergency, you can add just
water to the cooling system to reach a
vehicle service station. Have the system
checked by an authorized dealer as soon as
possible.
Note: Prolonged use of incorrect dilution
of the coolant can cause engine damage
from corrosion, overheating or freezing.
Note: Do not add coolant further than the
MAX mark.
1. Remove the filler cap. Any pressure will
escape slowly as you unscrew the cap.
2. Add a 50/50 mixture of coolant and
water using fluid that meets the Ford
specifications. See Technical
Specifications (page 179).
3. Replace the filler cap. Turn it until you
feel a strong resistance.
167
WARNINGS