Jump Starting The Vehicle - Ford TOURNEO CONNECT 2015 Owner's Manual

JUMP STARTING THE VEHICLE

WARNINGS
Do not use fuel lines, engine rocker
covers or the intake manifold as
grounding points.
Connect batteries with only the same
nominal voltage.
Always use booster cables with
insulated clamps and adequate size
cable.
Note: Do not disconnect the battery from
your vehicle s electrical system.
To Connect the Booster Cables
A Vehicle with low charge battery
B Booster battery vehicle
Tourneo Connect (CHC) Vehicles Built From: 10-03-2014, Vehicles Built Up To: 31-12-2014, Long Wheelbase Kombi/Short Wheelbase Kombi, Base/Base High Payload/Titanium/Titanium High Payl
Roadside Emergencies
144
C Positive connection cable
D Negative connection cable
1. Position the vehicles so that they do
not touch one another.
2. Switch off the engine and any electrical
equipment.
3. Connect the positive (+) terminal of
vehicle B with the positive (+) terminal
of vehicle A (cable C).
4. Connect the negative (-) terminal of
vehicle B to the ground connection of
vehicle A (cable D).
WARNINGS
Do not connect directly to the
negative (–) terminal of the battery
with low charge.
Make sure that the cables are clear
of any moving parts and fuel delivery
system parts.
To Start the Engine
1. Run the engine of vehicle B at a
moderately high speed.
2. Start the engine of vehicle A.
3. Run both vehicles for a minimum of
three minutes before disconnecting the
cables.