Ultra Start 25 series Install Manual page 7

REMOTE VEHICLE STARTER
Wiring Diagram
Temperature Sensor (LT Series Only)
ACTIVE RF ANTENNA**
**The antenna MUST be connected for the system to operate
Door Lock Output (-)250ma
12v Output (+)250ma (see notes below)*
Door Unlock Output (-)250ma
2nd Door Unlock Output (-)250ma
Pre-Warn Sensor Input (-)
Full-Warn Sensor Input
Ground Output (-)250ma
12Volt Output (+)250ma
*The centre pin of the keyless entry harness is ONLY available with
plug-in devices such as the VP-1, DL-3, DL-7 and Data Bus Modules.
Overloading this output will damage the remote starter.
Horn/ Aux #5 Output (-)250ma
12Volt Disconnect/ Start Input (+)
NOTE: 250ma outputs are low current and may require
additional parts (relays) to active optional features.
Output on White wire Jumper position
Second Starter
Second Accessory
Second Ignition
NOTE: The jumpers control the output from the WHITE wire on the
main 6- pin harness. This is an 30amp relayed output.
*The factory default setting of the Selectable Output jumper is position #3.
(-) Input Trigger
Status Leds
Aux #6 Output
Position 1
Position 2
Position 3
INSTALL MANUAL
Program Button
GREEN
RED*
BLUE
PINK
BLUE
GREEN
BLACK
RED
GREEN
PINK
BLUE
PAGE 7
continued...
1
2
1
2
3
4
1
2
3
4
N/A
1
2
3
3 2 1