Ultra Start 25 series Install Manual page 17

REMOTE VEHICLE STARTER
Menu 1- User Settings
Setting 6 Sensor Enable/Disable
1) Sensor Disabled
*2) Sensor Enabled
Press & Release the Program Button 6 Times (Setting 6) Confirmed with 6 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/ siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 7 Passive/Active Arming
1) Passive Arming
2) Active Arming with Rearm 2 Flashes/Chirps
*3) Active Arming
Press & Release the Program Button 7 Times (Setting 7) Confirmed with 7 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/ siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 8 Auxiliary Outputs
1) Auxiliary Outputs w/Unlock
2) Auxiliary Outputs
*3) Normal Operation
Press & Release the Program Button 4 Times (Setting 4) Confirmed with 4 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/horn (optional) honks, then release.
Press & Release the Program Button to proceed to the next step
Menu 2- Additional Settings
Ignition 3x
On/Off
On/Off On
Setting 1 Secure Valet Mode
1) Secure Valet
*2) Normal Valet
Press & Release the Program Button 1 Time (Setting 1) confirmed 1 LED flashes.
Press & Hold the Program Button until the appropriate # of park light/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 2 Parking Light/Trunk Output
1) 30 sec. Output
2) Negative Park Lights
*3) Park Lights
Press & Release the Program Button 2 Times (Setting 2) confirmed 2 LED flashes.
Press & Hold the Program Button until the appropriate # of park light/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
1 Flash/Chirp
2 Flashes/Chirps
1 Flash/Chirp
3 Flashes/Chirps
Press and
Press and
Release the
Release the
Program
Button
Menu 2
1 Flash/Chirp
2 Flashes/Chirps
1 Flash/Chirp
2 Flashes/Chirps
3 Flashes/Chirps 2 Flashes when
...continued
Impact Sensor Disabled
Impact Sensor Enabled
Auto Arms 30 seconds after last door is closed
If unlock is pressed and no door is opened
Arms with remote transmitter only
1 Flash/Honk
2 Flashes/Honks
3 Flashes/Honks
Press and Release
the Program Button
# of Times for
button for
Setting Chosen
(time required to set the system into Service Mode)
Hold the Program Button for 15 seconds
Hold the Program Button for 5 seconds
(14 pin auxiliary connector pins 2&8)
On for 30 seconds when
Switches the Park Lights/Trunk Outputs
INSTALL MANUAL
Auxiliary Outputs with Unlock
Auxiliary Outputs ONLY
No Auxiliary Outputs
Press and Hold
the Program Button
to Change Option
is pressed
is pressed
PAGE 17