Ultra Start 25 series Install Manual page 19

REMOTE VEHICLE STARTER
Menu 3- Starter Settings
Setting 2 Gas/Diesel Mode
1) (+) Input
.2) Time Delay
*3) Gas/ (-) Input
Press & Release the Program Button 2 Times (Setting 2) Confirmed with 2 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/horn (optional) honks, then release.
Press & Release the Program Button to proceed to the next step.
Setting 3 Rearm Output (Auxiliary Connector Pin 1)
1) Type 1
2) Type 2
*3) Factory Re-arm
Press & Release the Program Button 3 Times (Setting 3) Confirmed with 3 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/horn (optional) honks, then release.
Press & Release the Program Button to proceed to the next step.
Setting 4 Run Time
1) 4 Minutes
2) 45 Minutes
*3) 15 Minutes
Press & Release the Program Button 4 Times (Setting 4) Confirmed with 4 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/horn (optional) honks, then release.
Press & Release the Program Button to proceed to the next step.
Setting 5 Maximum Crank Time
1) 10 Seconds
2) 3 Seconds
*3) 5 Seconds
Press & Release the Program Button 5 Times (Setting 5) Confirmed with 5 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/horn (optional) honks, then release.
Press & Release the Program Button to proceed to the next step.
Setting 6 Anti-Grind/Starter Kill
1) Active 1 Flash/Honk
2) Passive 2 Flashes/Honks (-)When locked/ 30 seconds after ignition is OFF or
*3) GWR 3 Flashes/Honks (-) Output during remote start only. (Anti-grind/ Bypass)
Press & Release the Program Button 6 Times (Setting 6) Confirmed with 6 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/horn (optional) honks, then release.
Press & Release the Program Button to proceed to the next step.
Setting 7 Safety Start
1) Safety On 1 Flash/Honk
*2) Safety Off 2 Flashes/Honks
Press & Release the Program Button 7 Times (Setting 7) Confirmed with 4 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/horn (optional) honks, then release.
Press & Release the Program Button to proceed to the next step.
1 Flash/Honk
2 Flashes/Honks
3 Flashes/Honks
1 Flash/Honk
2 Flashes/Honks
3 Flashes/Honks
1 Flash/Honk
2 Flashes/Honks
3 Flashes/Honks
1 Flash/Honk
2 Flashes/Honks
3 Flashes/Honks
(-)When locked and during remote start (Anti-Grind).
Press the
- continued
(+) Glow Plug input. Waits maximum 30 seconds
Waits for approximately 15 seconds.
Waits 2 seconds if no diesel input is detected.
Pulse after start and with lock.
Pulse after start only.
Pulse with lock and after starter shutdown.
Runs for approx. 4 minutes when activated.
Runs for approx. 45 minutes when activated.
Runs for approx. 15 minutes when activated.
10 sec max time that the starter will stay engaged.
3 sec max time that the starter will stay engaged.
5 sec max time that the starter will stay engaged.
(Auxiliary Connector Pin 4)
button twice within 3seconds to remote start.
Press the button once to remote start vehicle.
INSTALL MANUAL
PAGE 19
pressed