Removing The Rear Wheel; Installing The Rear Wheel - Husqvarna 2014 FC 450 EU Owner's Manual

13 WHEELS, TIRES
13.3

Removing the rear wheel

13.4

Installing the rear wheel

Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
–
Mount and tighten screw
Guideline
Screw, front wheel spindle
–
Activate the hand brake lever multiple times until the brake linings are in contact with
the brake disc.
–
Remove the motorcycle from the lift stand. (
–
Pull the front brake and compress the fork powerfully a few times.
The fork legs straighten.
L00212-11
–
Tighten screws
Guideline
Screw, fork stub
x
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
Press the brake caliper onto the brake disc by hand in order to push back the brake
piston.
Info
Make sure when pushing back the brake piston that you do not press the
brake caliper against the spokes.
–
Remove nut
–
Remove chain adjuster
rear wheel to be pushed forward.
–
Push the rear wheel forward as far as possible. Remove the chain from the rear
sprocket.
Info
Protect the components against damage by covering them.
–
Holding the rear wheel, withdraw the wheel spindle. Take the rear wheel out of the
swing arm.
Info
B01790-10
Do not operate the foot brake when the rear wheel is removed.
Always lay the wheel down in such a way that the brake disc is not damaged.
–
Remove spacers
101848-10
x
2 .
3
.
1
.
2 . Withdraw wheel spindle
4
.
M24x1.5 45 Nm (33.2 lbf ft)
p. 32)
M8 15 Nm (11.1 lbf ft)
p. 32)
3 only enough to allow the
65