Map-Select Switch For The Basic Setting; Map-Select Switch For Vehicle Operation; Overview Of Indicator Lamps; Opening The Filler Cap - Husqvarna 2014 FC 450 EU Owner's Manual

6 CONTROLS
6.6 Map‑Select switch for the basic setting
6.7 Map‑Select switch for vehicle operation
6.8

Overview of indicator lamps

6.9

Opening the filler cap

Danger
Fire hazard Fuel is highly flammable.
–
Never refuel the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no fuel
is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
–
The fuel in the fuel tank expands when warm and may emerge if overfilled. Follow the instructions on refueling.
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
–
Fuel must not come into contact with the skin, eyes, or clothing. Do not breathe in the fuel vapors. If contact occurs with the
eyes, rinse with water immediately and contact a physician. Immediately clean contaminated areas on the skin with soap and
water. If fuel is swallowed, contact a physician immediately. Change clothing that is contaminated with fuel. Store fuel prop-
erly in a suitable canister and keep away from children.
Warning
Environmental hazard Improper handling of fuel is a danger to the environment.
–
Do not allow fuel to get into the ground water, the ground, or the sewage system.
The Map‑Select switch for the basic setting
Possible states
1
2
3 - 9, 0
B01918-10
The Map‑Select switch for the basic setting is used to make a preselection of the
engine characteristics.
The Map‑Select switch for vehicle operation
bar.
Possible states
The Map‑Select switch for vehicle operation is used to change the engine character-
B01919-10
istics on the handlebar. This change is activated when the engine is idling or after the
motorcycle is restarted.
Possible states
B01831-10
SOFT – The mapping with reduced peak performance for better rideabil-
ity is activated.
ADVANCED – The mapping for performance with a very direct response
is activated.
STANDARD – The mapping for performance with a balanced response is
activated.
STANDARD – STANDARD mapping is always activated in this setting.
SOFT or ADVANCED – The mapping that is set on
the Map‑Select switch for the basic setting is activated in this setting.
FI warning lamp (MIL) lights up/flashes orange – The OBD (on-board
diagnosis) has detected an emission- or safety-critical error.
1
is fitted under the seat.
1
is fitted on the right side of the handle-
12