Installing The Lower Triple Clamp - Husqvarna 2014 FC 450 EU Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.12

Installing the lower triple clamp

3 0 0 3
2 0 0 2
1 0 0 1
x
Main work
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
–
Check whether the upper steering head seal
–
Slide on protective ring
800221-10
–
Position the upper triple clamp with the handlebar.
–
Mount screw
B01867-10
–
Position the fork legs.
Bleeder screws
Info
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the upper
triple clamp.
B01868-10
–
Fully tighten screws
Guideline
Screw, bottom triple clamp
B01869-10
–
Tighten screw
Guideline
Screw, top steering head
B01870-10
p. 92)
2 and O-ring 3
4
but do not tighten yet.
5
face forward.
6
.
4
.
1
is correctly positioned.
.
M8 12 Nm (8.9 lbf ft)
M20x1.5 12 Nm (8.9 lbf ft)
36