Installing The Fuel Tank - Husqvarna 2014 FC 450 EU Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.36

Installing the fuel tank

Danger
Fire hazard Fuel is highly flammable.
–
Never refuel the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no fuel
is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
–
The fuel in the fuel tank expands when warm and may emerge if overfilled. Follow the instructions on refueling.
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
–
Fuel must not come into contact with the skin, eyes, or clothing. Do not breathe in the fuel vapors. If contact occurs with the
eyes, rinse with water immediately and contact a physician. Immediately clean contaminated areas on the skin with soap and
water. If fuel is swallowed, contact a physician immediately. Change clothing that is contaminated with fuel.
–
Remove screw
B01891-10
–
Pull both spoilers off of the sides of the radiator bracket and lift off the fuel tank.
B01892-10
x
Main work
–
Check the throttle cable routing. (
–
Position the fuel tank and fit the two spoilers to the sides of the radiator bracket.
–
Make sure that no cables are trapped or damaged.
–
Mount the fuel tank breather.
–
Mount and tighten screw
Guideline
Remaining screws, chassis
B01891-11
–
Mount and tighten screws
Guideline
Remaining screws, chassis
B01890-11
4 with the rubber bushing.
p. 52)
1
with the rubber bushing.
2
with the collar bushing.
M6 10 Nm (7.4 lbf ft)
M6 10 Nm (7.4 lbf ft)
47