Panasonic U-26PE1U6 Technical Data & Service Manual page 200

7-26. Wiring System Diagram for Multiple Remote Controllers
When installing multiple remote controllers
This multiple system is used for operating the unit(s) at
different positions. (A maximum of 2 signal receiving
units can be installed.)
Setting method
To execute this control, make the setting according
to the following procedure.
(1) Of the two installed signal receiving units, make
one the main signal receiving unit (factory-shipped
state).
(2) On the other signal receiving unit, change the
address connector on the PCB from main to sub
position.
In this state, it functions as a sub-signal receiving
unit.
1
Basic wiring diagram
CAUTION
To operate 1 indoor unit with 2 signal receiving units
set at different locations.
Carry out the wiring correctly
(incorrect wiring will damage
the equipment).
Signal receiving unit
(main) (sub)
(Option)
1 2 1 2
Remote control
cable terminal
1 2
board
Indoor unit
Earth
1-192
1. Specifications
Connection wiring