Panasonic U-26PE1U6 Technical Data & Service Manual page 179

6-56. Required Minimum Space for Installation and
Service
(1) Dimensions of suspension bolt pitch and unit
Length
Type
inch 48-17/64
26
mm
inch 62-43/64
36, 42
mm
(2) Refrigerant tubing • drain hose position
Left side
Left drain position
Closed with rubber stopper
at time of shipment.
(3) Unit opening position (Refrigerant tubing • drain hose • power inlet port • remote control wiring inlet port)
Left-side drain hose
outlet port
Rear outlet port (Figure shows view from front)
Outside air intake duct
connection port
(ø3-15/16 (100), cutout)
Left-rear side drain
hose outlet port
(cutout)
A B C
50-13/64 9-1/4
1226 1275 235
62-19/32 9-1/4
1541 1590 235
Rear (Figure shows view from front)
Gas tubing
Left drain position
Liquid tubing
Right drain position
Top outlet port
Remote control wiring
and inter-unit wiring inlet port
Cover of tubing hole
Power Supply inlet
(Suspension bolt pitch)
Right drain position
Side cover
*1 Use a compass saw, jig saw or similar tool and cut along
the indented portion of the side cover and make a hole
inside the cover.
*2 When pulling the refrigerant tubing from the upper side,
cut along the indented portion and pass the tubing
through the hole.
NOTE
Be sure to use sealing putty to seal off the opening to
prevent dust.
1-171
1. Specifications
Unit: inch (mm)
Air intake
Air discharge
Fig. 1-181
Unit: inch (mm)
Right side
(Liquid tubing •
Gas tubing)
Fig. 1-182
Unit: inch (mm)
Right-side drain
hose outlet port
Fig. 1-183
1