Section 9: Installing The Accessories; Installing The Firestones - Montigo PL42DF Installation & Maintenance Manual

Step 8:
Removing the Door:
Grasp the Door on either side, usually midway and lift upward,
lift the door carefully up and away from the front of the fireplace.
See Figures 23f. Place the Door aside in a safe place while
maintenance and / or cleaning is being performed.
Figure 23f. Removing and installing the glass doors.
Installing the Door:
To install the door, hook the top edge of the door frame into place.
Lower the door into position and follow the previous steps shown
in reverse order.
WARNING
When installing the replace - gas lines, ttings, accesso-
ries or any other objects cannot impede the proper
movement of the door buckles.
XG0217 -160215.1
Installation

Section 9: Installing the Accessories

Installing the Firestones

The PL42DF* is supplied with firestones. Remove the
Door as shown in the previous Instruction. Follow these
instructions to ensure all parts are removed or replaced
as required. Once the glass door is removed place the
firestones randomly across the pan and the burners as
described in Figure 24 to 24d.
Note: Only cover the burner with one layer of designer firestones.
Figure 24. Installation of the firestones. (Ensure ONLY one
layer of firestones cover the surface).
Figure 24a. Spreading the firestones evenly and make sure
there are no firestones covering the pilot.
Figure 24b. Completed firestone installation.
WARNING: This appliance is intended for use only with
the included Montigo burners and accessories.
Never install or add any additional or alternative media,
rock wool or other material in this appliance.
The use of additional or alternative materials may pose
potential safety hazards, damage to the appliance, and
void manufacturer's warranty.
PL42DF* Indoor Gas Fireplace
Page 25