Removing and Replacing Parts : Dell Inspiron 8100
connector cutout.
Removing the RJ-11/RJ-45 Board
1. Follow the instructions in
2. Remove the
3. Remove the M2.5 x 4-mm screw from the RJ-11/RJ-45 board.
NOTICE:
The plastic tab is fragile; pull it back only far enough to remove the
board assembly.
4. Reach into the enclosure and, while pulling the tall plastic tab away from the
board assembly to release it, lift out the assembly.
When replacing the RJ-11/RJ-45 board assembly, protect the wiring harness by
routing it between the plastic posts as shown in the following figure.
file:///F|/Service%20Manuals/Dell/Inspiron/8100/remove.htm (55 of 56) [2/28/2004 7:37:23 AM]
"Preparing to Work Inside the
system
board.
Computer."