Motor, Outlet Thermostat, Jockey Pulley And Belt Switch Replacement - Fisher & Paykel DE09 Service Manual

4.5 Motor, Outlet Thermostat, Jockey Pulley and Belt
Switch Replacement
• Disconnect the power supply.
• Remove the drum assembly.
• Remove the outlet screw securing the outlet thermostat. The thermostat can then be removed
from the fan housing. Replace the wires in the same order.
• Remove the connector from the motor.
• Remove the two screws that secure the motor bracket to the base at the rear of the motor.
• Remove the two long black screws that secure the fan housing to the front bracket of the
cabinet.
• Slide the motor and bracket assembly towards the rear of the cabinet.
• Remove the jockey pulley and arm assembly.
• Disconnect the wires to the belt switch.
• Disconnect the mains harness connector at the rear of the motor and feed out from under the
motor.
• Feed the door and sensor harness through the cabinet bracket and out from under the motor.
• Remove the motor and bracket assembly from the cabinet.
• Remove the fan from the motor.
• Remove the screw from the front motor clamp.
• Remove the spring clip holding the back of the motor to the bracket.
• Remove the motor from the bracket.
Jockey Pulley
Belt Pulley
Connector
Motor
Outlet Thermostat
Fan Housing
27
479536