Table of Contents
Advertisement
427939
6.10 Fan Removal DE40F56
1. Remove the rear panel refer to sec 6.4.
2. Remove the 4 screws from the steel plate clamping the fan to the motor shaft.
3. Pull the fan off.
Reassemble in reverse order aligning the plates each side of the fan. DO NOT USE solvents,
cleaning fluids, oil or grease near the plastic fan. Use only a clean cloth.
6.11 Motor Removal
1. Remove the top panel, refer to sec 6.3, the rear Panel, refer to sec 6.4, and the fan (DE40F56A
only), refer to sec 6.10
2. It is easier if the drum is also removed refer to sec 6.5.
3. Remove the drive belt from jockey pulley and vee pulley on the motor shaft.
4. Remove the 2 motor mounting spring clips at each end of the motor using service tool P/No
479349
5. The motor can then be lifted away from the motor mounts enabling access to the motor wiring
6. Disconnect the harness from the motor and remove.
Reassemble in reverse order. Take care to route the wires away from sharp edges on the motor
mounting brackets.
6.12 Fan Removal DE50F56
The fan is held on to the motor shaft by a fan boss to which the fan is clamped.
1. Remove the motor, refer to sec 6.11
2. Remove 4 screws that hold the fan flange disc to the clamping disc behind the fan.
3. The fan may now be removed from the boss.
4. The fan boss can then be removed from the motor shaft by loosening the Allen key set screw
on the fan boss.
5. Then withdraw the boss from the shaft of the motor.
Reassemble in reverse order.
6.13 Motor Driving Pulley Removal
The motor driving pulley is held on the shaft by a role pin through the pulley and motor and also by
an Allen key set screw.
1. Remove the motor, refer to sec 6.11
2. Drive out the roll pin that fits through the pulley and shaft. This may be done with a pin punch.
3. Loosen the Allen set screw of the motor pulley.
4. The pulley can then be withdrawn from the motor shaft.
Reassemble in reverse order.
6.14 Jockey Pulley Removal DE40F56
1. Remove the rear panel, refer to sec 6.4.
2. Remove the tension from the belt.
3. Remove the tension spring from the jockey pulley to the motor mounting bracket.
4. Push the arm away to lift out one side of the pulley, and then push the pulley away.
Reassemble in reverse order. The spring goes in between the top and second slots of the jockey
pulley arm.
6.15 Jockey Pulley Removal DE50F56
1. Remove the rear panel, refer to sec 6.4.
2. Remove the tensioning spring between the two jockey pulley arms.
3. The jockey pulley arms can be removed from the base of the cabinet by straightening the bent
tabs on each arm.
4. Access to these tabs is under the base of the cabinet.
5. After straightening, the arms can then be withdrawn by holding them to one side of the slot and
lifting the other edge from the slot.
Reassemble in reverse order.
NOTE: The jockey pulley arms and rollers are at two different heights. The longer of the two
arms/rollers fit closest to the cabinet side.
14
Hide quick links:
Advertisement
Table of Contents
