Exmark LAZER Z Operator's Manual page 42

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
4.2.5
4.2.6
4.2.7
NOTE: When installing a new belt, it is necessary to reposition the right
adjusting pulley upward in the slot in order to position the center of the
spring loaded pulley between the alignment holes.
Deck Belt Tension:
a) The deck belt is tensioned by a self-tensioning idler, no adjustment is
necessary.
Adjust Seat Switch:
a) If necessary, adjust the seat actuator rod length to where the machine will
shut off when the operator raises off the seat (with brake disengaged or
PTO engaged) but will continue to run with operator in seat (a slight shift in
weight should not shut machine off).
For all units: Normal adjustment is when length of spring is 2.09" (5.3 cm)
(with seat up).
NOTE: To prevent the engine from cutting out when operating over
rough ground, the unit is equipped with a time-delayed seat switch.
When the operator raises off the seat with either the brake disengaged
or the PTO engaged, the engine should stop after 1/2 second has
elapsed.
b) To adjust seat switch actuator rod length, loosen lock nut on bottom of the
actuator rod (5/16 x 7" bolt) and adjust the nuts to move the actuator
plate/washer up or down on the rod, then retighten.
Belt Guide Adjustment:
a) Stop engine, wait for all moving parts to stop, and remove key. Engage
parking brake.
b) Remove the belt shield on the right side of mower deck.
c) Note belt guide bolted to deck near the shield support stud and right-hand
pulley. Guide should be 1/8" (3.2 mm) away from the belt, with bolt-end of
guide near end of slot (See Figure 10).
d) If adjustment is necessary, loosen the bolt securing the belt guide and
make proper adjustment. Tighten hardware.
www.mymowerparts.com
FIGURE 9
FIGURE 10
37