Exmark LAZER Z Operator's Manual page 22

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
3.1.3
3.1.4
3.1.5
3.1.6
3.1.7
3.1.8
POTENTIAL HAZARD
♦ Machine can spin very rapidly by
positioning one lever too much ahead of
the other.
WHAT CAN HAPPEN
♦ Operator may lose control of the
machine, which may cause damage to
the machine or injury.
HOW TO AVOID THE HAZARD
♦ Use caution when making turns.
♦ Slow the machine down before making
sharp turns.
Tracking Adjustment Knob: Located under the seat on the RH pump control
link. Rotating this knob allows fine tuning adjustments so that the machine
tracks straight with the drive levers in the full forward position.
Stop machine and wait for all moving parts to stop. Engage park brake. Unhook
seat latch and tilt seat forward to gain access to the tracking knob. Rotate the knob
clockwise (as viewed from the rear of the machine) to cause the machine to track
more to the right and counterclockwise to cause the machine to track more to the
left. Adjust in quarter-turn increments until the machine tracks straight. Check that
the machine does not creep when in neutral with the park brakes disengaged.
IMPORTANT: Do not rotate the knob too far, as this may cause the machine
to creep in neutral. Refer to section 4.2.12 for control linkage adjustment.
PTO Engagement Switch: Located on right fuel tank.
Switch must be pulled out to the "ROTATE" position to engage the blades.
Switch is pushed in to the "STOP" position to stop the blades.
Choke Control: (All units except Kohler EFI) Located on right fuel tank.
Choke is used to aid in starting a cold engine. Moving the choke lever forward
will put the choke in the "ON" position and moving the choke lever to the rear,
to the detent, will put the choke in the "OFF" position. DO NOT run a warm
engine with choke in the "ON" position.
Throttle Control: Located on right fuel tank.
Throttle is used to control engine speed. Moving throttle lever forward will increase
engine speed and moving throttle lever to the rear will decrease engine speed.
Moving the throttle forward into the detent is full throttle.
Brake Lever: Located on left side of unit, just to the front of the console. The
brake lever engages a parking brake on the drive wheels.
Pull the lever up and rearward to engage the brake.
Push the lever forward and down to disengage the brake.
The unit must be tied down and brake engaged when transporting.
Ignition Switch: Located on right fuel tank.
The ignition switch is used to start and stop the engine. The switch has three
positions "OFF", "ON" and "START". Insert key into switch and rotate clockwise
to the "ON" position. Rotate clockwise to the next position to engage the starter
(key must be held against spring pressure in this position).
www.mymowerparts.com
CAUTION
17