Exmark LAZER Z Operator's Manual page 33

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
4.1.11 Change engine oil:
4.1.12 Check hydraulic oil level:
4.1.13 Check tire pressures:
4.1.14 Check condition of belts:
d) If plugging of the screen is observed, remove arrester and shake loose
particles out of the arrester and clean screen with a wire brush (soak in solvent
if necessary). Re-install arrester on exhaust outlet.
Service Interval: 100 hrs.
NOTE: Change oil and filter after first five (5) hrs. of operation.
a) Stop engine, wait for all moving parts to stop, and remove key. Engage
parking brake.
b) Drain oil while engine is warm from operation.
c) The oil drain hose is located on right hand side of engine.
Place pan under machine to catch oil. Remove plug from end of drain
hose. Allow oil to drain and replace oil drain plug. Torque plug to
20-24 ft-lbs.
d) Replace the oil filter every other oil change. Clean around oil filter and
unscrew filter to remove. Before reinstalling new filter, apply a thin coating of
oil on the surface of the rubber seal. Turn filter clockwise until rubber seal
contacts the filter adapter then tighten filter an additional 2/3 to 3/4 turn.
e) Clean around oil fill cap and remove cap. Fill to specified capacity and replace
cap. Use oil recommended in engine owner's manual. DO NOT overfill.
f) Start the engine and check for leaks.
Service Interval: 40 hr.
a) Stop engine and wait for all moving parts to stop.
b) Unhook seat latch and tilt seat up.
c) Clean area around hydraulic reservoir cap and remove cap. Oil level
should be to the top of the baffle inside the tank. If not, add oil. Use only
Mobil 1 15W-50 synthetic motor oil. Replace hydraulic reservoir cap and
tighten until snug. Do not overtighten.
NOTE: The baffle is labeled "HOT" and "COLD". The oil level varies with
the temperature of the oil. The "HOT" level shows the level of oil when it is
at 225°F (107°C). The "COLD" level shows the level of the oil when it is at
75°F (24°C). Fill to the appropriate level depending upon the temperature
of the oil. For example: If the oil is about 150° F (65°C), fill to halfway
between the "HOT" and "COLD" levels. If the oil is at room temperature
(about 75° F (24°C)), fill only to the "COLD" level.
Service Interval: 40 hrs.
a) Stop engine, wait for all moving parts to stop, and remove key. Engage
parking brake.
b) Check tire pressure in drive tires.
c) Inflate drive tires to 13 psi (90 kPa).
d) Caster tires do not need to be inflated.
NOTE: Do not add any type of tire liner or foam fill material to the tires.
Excessive loads created by foam filled tires may cause failures to the hydro drive
system, frame, and other components. Foam filling tires will void the warranty.
Service Interval: 40 hrs.
a) Stop engine, wait for all moving parts to stop, and remove key. Engage
parking brake.
www.mymowerparts.com
28