Vermont Castings RNVOD 3340 Homeowner's Installation And Operating Manual page 21

4. Replace burner. Slide the burner in at an angle
with left side lower than the right side. Slide the left
side onto the injectors, making sure the burner leg
remains at a 90° angle to the base. Lower the right
hand side down in to place. Make sure the burner is
as far left as possible and the injector shoulders are
inside the burner.
NOTE: It is very critical to keep the left burner leg,
which holds the injectors, at a 90° angle to the base.
(Fig. 39) This keeps the orifices aligned with the
tubes inside burner. Failure to do so could affect the
flame appearance and performance of the unit.
5. Place conversion label on valve.
6. Reinstall the right and left log bracket assembly.
7. Reinstall the rear log bracket.
8. Replace logs.
9. Replace glass and stove front.
Conversion is complete.
Kit #
000-5009
Kit #
000-5010
20004409
Table 2 Injector Orifice Size Matrix
Conversion to Natural Gas
Front Part #
#51 / .067" 30000449
Conversion to LP
Front Part #
#57 / .043" 20004587
Table 3 Air Shutter Adjustment
Model
RNVOD
Radiance Natural Vent Gas Heater
Rear Part #
#40 / .098" 20004263
Rear Part #
#54 / .055" 20000130
Natural Gas LP
1¹⁄₂" Fully closed
Input (BTU/h)
Minimum Maximum
25,000 35,000
Input (BTU/h)
Minimum Maximum
27,500 35,000
21