Table of Contents
Advertisement
Radiance Natural Vent Gas Heater
A
A
Fig. 13 Attach rear shroud cover plate to the rear shroud.
ST372
Attach rear
skirt cover
5/19/00 djt
Rheostat
Retaining Collar
Rheostat Knob
Fig. 14 Attach the fan rheostat.
ST347a
Install the Optional Fan
JUV
FK28
These instructions are for stoves with serial numbers
rheostat install
starting at #1457 (RNVODRN), #1944 (RNVODRP).
9/21/00
If you are installing the optional convection Fan Kit
#2767 (FK26), continue here. It is easiest to install fan
kit before connecting gas line. If you are not installing a
Fan Kit, proceed to Venting System Assembly.
1. The fan kit includes a Blower Assembly and a Rheo-
stat Assembly, connected by a cable. The Blower
Assembly mounts to the bottom rear of the stove,
and the Rheostat mounts to the left side of the valve.
The assembly includes a 'snapstat' which auto-
matically turns the fan On (or Off) above (or below)
approximately 109˚. The Rheostat also provides a
range of fan speed settings from Off (which over-
rides the snapstat function) to High. Unpack and
inspect the Blower assembly. Confirm that the fan
spins freely.
2. Loosen the four phillips head screws which secure
the rear shroud to the stove sides. (Fig. 15)
3. Carefully pull the shroud assembly away from the
rear of the stove.
4. With the rear shroud assembly in the upright posi-
tion, set the bottom of the shroud on a padded
surface to prevent scratching the surface. Unfasten
the four phillips head screws which attach the outer
shroud to the inner duct assembly.
10
Rear Shroud
Cover Plate
ST371
Rheostat
ST347a
Rear Shroud
Assembly
Fig. 15 Remove rear shroud.
5. Attach the fan assembly to the fan bracket provided
in the finish bag. Use the #10 sheet metal screws
provided with fan kit. Do not remove finger guard
screws. (Fig. 16)
ST713fan remove shroud
radiance
11/99
ST669
Fig. 16 Attach the fan assembly to the fan bracket.
6. Connect snapstat leads. Disconnect the snapstat
module from the leads inside the snapstat bracket.
ST669
(Fig. 17) Bend open the snapstat bracket. Use
RUVSOD
needle nose pliers to remove the black plastic grom-
attach fan to bracket
met from the bracket. Discard the bracket. Insert the
7/01
grommet and wires into the large hole at the bottom
right corner of the inner shroud. Feed the snapstat
wire leads through the grommet into the stove interi-
or. Connect the two wires to the two snapstat exten-
sion leads attached to the inner shroud or, on some
models, in between the inner and outer shroud.
7. Position the fan assembly so the ducts slide between
the inner and outer shroud. The inner shroud should
engage with the two slots in the ends of the bracket
so that bracket and shroud are interlocked. (Fig. 18)
Secure the bracket with the four sheet metal screws
provided in the finish bag.
ST713
Snapstat
Wire
Rheostat
Wire
Fan
Bracket
Finger Guard
20004409
Hide quick links:
Advertisement
Table of Contents
