Vermont Castings RNVOD 3340 Homeowner's Installation And Operating Manual page 11

Fig. 17 Remove the snapstat and grommet from the bracket
and insert the grommet into the inner shroud.
Outer
Shroud
ST194
Fig. 18 Position the fan to engage the inner shroud with the
fan bracket slots and secure with sheet metal screws.
8. Route the rheostat wire assembly to the right
ST194
between the inner and outer shroud. Run the wire
attach fan to shroud
11/99
through the slots at the bottom right corner of the
inner shroud. Some models have the extension wire
assembly attached to the inner shroud.
9. Refasten the outer shroud to the inner duct assem-
bly.
10. Install the snapstat by loosening the front screw on
the inner side of the duct (Fig. 19) slide the snapstat
under the head of the screw and tighten. Connect
the leads to the snapstat. Make sure the snapstat
assembly is mounted straight front to back.
Left Air Duct
Fig. 19 Install the snapstat and connect the extension wire
terminals. View is with top removed, however, access is
available through the rear when installing fan before gas line
connection.
20004409
Snapstat Bracket
Snapstat Module
Pinch
Grommet to
Remove
ST670
ST640
RUVSOD
Slot
snapstat
7/01
Inner Shroud
Slot
Snapstat
ST671
Radiance Natural Vent Gas Heater
11. Slide shroud assembly over the sides and fasten the
four screws loosened earlier.
12. The rheostat control switch attaches to the left side
of the valve bracket at the front of the stove. (Fig. 20)
•
Remove retaining nut from shaft of rheostat. (if
preinstalled)
•
Insert the rheostat through the hole in the back
of the left side of the valve bracket, aligning the
locator pin with the smaller hole in that bracket.
•
Thread the retaining nut onto the shaft of the
rheostat, tightening with a wrench. Do not over-
tighten.
•
Attach the control knob to the rheostat shaft.
•
Use the wire tie to secure the fan and rheostat
wire harnesses together.
Retaining Nut
Control Knob
Fig. 20 Attach rheostat to left side of valve.
13. Plug the power cord into a standard grounded 110
volt household outlet. If the fan control knob is not
turned to the OFF position, the fan will turn on when
the temperature at the snapstat reaches approxi-
mately 109°F.
MOTOR
BLK
POWER
Fig. 21 #2767 / FK26 Fan wiring diagram.
ST196
FK26 fan diangram
11/99
Rheostat
ST347a
ST347a
JUV
FK28
rheostat install
9/21/00
BLK
SNAPSTAT
WHT
ON/OFF
RHEOSTAT
ST196
11