Advertisement
STEP 2
A.) Push two Square Inner Caps (#35) into the Backrest Support (#6). Push
one M6 x 15mm Screw (#24) and Rubber Bumper (#37) into the Incline Support
(#7). Attach the Incline Support (#7) in between the two Backrest Supports (#6).
B.) Attach the Pivot of the Backrest Supports (#6) to the Pivot on the Center Support
Frame (#1). Secure them with one M12 x 180mm Bolt (#17), two M12 Washers
(#28), and one M12 Nylon Locknut (#25).
C.) Attach two Long Dumbbell Pothook (#10) and Short Dumbbell Pothook (#11) to
the Back Support Frame (#2). Secure them with two M8 x 90mm Bolts (#19),
four M8 Washers (#30), and two M8 Nylon Locknuts (#27).
27
30
11
10
1
25
28
2
10
6
6
28
17
24
30
11
19
35
35
7
37
Advertisement
