Advertisement
ASSEMBLY INSTRUCTION:
STEP 1
26
27
3
30
30
33
34
4
A.) Push two Inner Caps (#33) into the Front Stabilizer (#4). Push two Rubber End
Caps (#32) into the Rear Stabilizer (#5).
B.) Attach a U-shaped Sleeve (#34) onto the bracket on the Front Stabilizer (#4).
Make sure the opening on the Sleeve is facing towards the front. Attach the
Front Stabilizer to the Front Vertical Frame (#3). Secure it with two M8 x 80mm
Bolts (#20), four M 8 Washers (#30), and two M8 Nylon Locknuts (#27).
C.) Attach one U-shaped Sleeve (#34) to the bracket on the Rear Stabilizer (#5).
Attach the Back Support Frame (#2) to the Rear Stabilizer (#5). Secure it with
two M8 x 80mm Bolts (#20), four M8 Washers (#30), and two M8 Nylon Locknuts
(#27).
D.) Connect the Center Support Frame (#1) to the Back Support Frame (#2). Secure
the Lower hole with three M8 x 20mm Bolts (#22), six M8 Washers (#30), and
three M8 Nylon Locknuts (#27).
E.) Connect the Center Support Frame (#1) to the Front Vertical Frame (#3). Secure
the lower hole with one M10 x 90mm Bolt (#18), two M10 Washers (#29), and
one M10 Nylon Locknut (#26). Insert a L-shaped Lock Pin (#31) through the
upper hole to lock the Front Vertical Frame in position. Remove the Pin when
folding the bench for storage.
F.) Attach two L-shaped Brackets (#12) to the Center Support Frame (#1). Secure
them with one M8 x 90mm Bolt (#19), two M8 Washers (#30), and one M8 Nylon
Locknut (#27).
22
27
30
12
1
22
29
29
18
20
33
27
30
30
30
27
30 27
30
12
30
19
31
32
5
2
30
34
20
32
Advertisement
