Table of Contents
Advertisement
305.book Page 79 Tuesday, April 15, 2003 11:15 AM
Installation Settings
Tune in Satellite Signal. This option allows you to see the strength of the signal
your antenna is receiving.
Set VCR Code. This option allows you to store your VCR code in your receiver.
When you use timers and want to record your favorite program, your receiver will
control your VCR
Set Remote Control Address. This option allows you to control up to four
receivers in a centralized area with one or more remote controls. Each receiver
requires a separate address. The default address is 000.
Using the remote control:
• Press the Options button.
• Choose option 6 (Change System Settings).
• Choose option 3 (Installation Settings).
• On the Installation Settings menu, choose option 3 (Set Remote Control
Address). Now follow the instructions on the screen.
• If you have four receivers, you will have to change the addresses on three of
them: they will have addresses of 000, 001, 002, and 003.
Note: To program your remote control for each receiver, hold down the SAT key
on the remote control until the light flashes. Once the light begins to flash enter
the desired address (000, 001, 002, or 003).
DSR305 User Guide
Options
79
Advertisement
Table of Contents
