Table of Contents
Advertisement
305.book Page 42 Tuesday, April 15, 2003 11:15 AM
4
Using the remote control:
• Press the Options key.
• Choose option 6 (Change System Settings).
• Choose option 3 (Installation Settings).
• On the Installation Settings menu, choose option 2 (Set Remote Control
Address). Now follow the instructions on the screen.
• If you have four receivers, you will have to change the addresses on three of
them: they will have addresses of 000, 001, 002, and 003.
Note: To program your remote control for each receiver, hold down the SAT key
on the remote control until the light flashes. Once the light begins to flash enter
the desired address either 000, 001, 002, or 003.
42
Advertisement
Table of Contents
