Installation Menus; Manual Tune Menu - Motorola DSR-6050 Operator's Manual

3

Installation Menus

Manual Tune Menu

14
The purpose of the installation menus is to configure the ports and choose settings
that remain fixed over a period of time. These settings include video output format,
audio output format, Ethernet port addresses, and bypass mode operation. This
section describes in detail each of the installation menus, fields, and options
displayed on the LCD panel.
Return to the main top-level menu and then select the applicable menu group.
With the blinking cursor at the upper left, press ENTER button to return to the main
top-level menu. Press the 34 buttons until the cursor is at the Install label, and press
the ENTER button. The DSR-6050 displays the previously selected sub-menu.
Use this menu to begin to acquire a DigiCipher II system signal, by selecting a
transponder frequency for any of the eight L-Band inputs. In addition, this menu
allows a user to select the ASI input, as an alternative to RF ports 1-8.
Because many satellite broadcasters use standard C-band transponder center
frequencies, selecting a transponder number is the default tuning mode. Use the
Xpndr option in the Mode field and edit the Xpndr (transponder) field (described
on page 14), for tuning such signals.
For offset-frequency C-band, fractional transponders, or Ku-band satellite
broadcasts, use the LFreq option in the Mode field (described on page 14), and
directly edit the L-band frequency field.
The DSR-6050 does not actually require any distinction between C-band and Ku-
band satellite signals in order to tune and aquire a compatable signal. However,
correct modulation information is necessary. For details on modulation, see
"Modulation Menu" on page 14.