Panasonic CF-Y4 Service Manual page 16

2.2.12. Removing the Antenna Board (L),
(R)
· Preparation: Make sure that the steps in sections 2.2.1
to 2.2.4 and section 2.2.10 have been taken first.
1. Remove the Screw (V) of the Antenna Board (L).
Screw (V): DXHM0056ZA
2. Draw out the Antenna Cable (L) from the groove in the Top
Caset Ass'y, and remove the Antenna Board (L).
3. Remove the two Screws (W) of the Antenna Board (R).
Screw (W): DXHM0056ZA
4. Draw out the Antenna Cable (R) from the groove in the Top
Case Ass'y, and remove the Antenna Board (R).
Antenna Cable (L)
Screw (V)
Antenna Board (L)
2.2.13. Removing the Speaker (L), (R)
· Preparation: Make sure that the steps in sections 2.2.1
to 2.2.4 and section 2.2.10 have been taken first.
1. Peel off the Double-sided Tape from the Top Case Ass'y,
and remove Speaker (L) and (R).
Speaker (L)
Antenna Cable (R)
Screw (W)
Antenna Board (R)
Speaker (R)
2.2.14. Removing the LCD Front
Ass'y/Hinge (L), (R)
· Preparation: Make sure that the steps in sections 2.2.1
to 2.2.4 have been taken first.
1. Remove the Screw (Y) from the Hinge Cover (L) and the
Screw (Y) from Hinge Cover (R), and remove the Hinge
Cover (L) and (R) from the LCD Block.
Screw (Y): DRHM0075ZA
Screw (Y)
Hinge Cover (L)
2. Remove the Screw (Z) from the Hinge (L) and the Screw (Z)
from Hinge (R).
Screw (Z): DRHM0002ZA
3. Remove each of the Screws (a) and (b) from the LCD Front
Case Ass'y.
Screw (a): DRHM0075ZA
Screw (b): DFHE5025XA
4. Remove the three hooks near the Hinge (L) and (R), and
then remove the Hinge (L) and (R).
Screw (b)
Screw (Z)
Screw (a)
Hinge (L)
2-8
Hinge Cover (R) Screw (Y)
Screw (b)
Screw (a)
Hinge (R)
Screw (Z)