Yamaha 2002 TDM900 Service Manual page 77

A Fasten the handlebar switch lead (left) to the han-
dlebar with a band.
B Through the handlebar switch lead (left) and clutch
cable to the wire guide on the upper bracket.
C Fasten the main switch lead to the wire guide with a
clamp. There should be no slack between main
switch and wire guide. Cut the clamp tip with 3 to 8
mm left.
D Route the main switch lead through the cover 7 so
that it route beneath the handlebar switch lead
(left).
E Route the clutch cable through the hole in front of
the head pipe on the frame.
CABLE ROUTING
F Route the handlebar switch lead (right) and throttle
cable (2 cables) through the cover 8.
G Route the brake hose through the guide.
H Always route the cables so that the brake hose
passes by the outside of the throttle cables.
I Route the handlebar switch lead, brake hose and
throttle cable (2 cables) through the wire guide of
the upper bracket.
J Fasten the handlebar switch lead (right) to the han-
dlebar with a band.
K Fasten the horn lead to the front fork (left side) with
a clamp as shown in the drawing. Cut the clamp tip
with 3 to 8 mm left.
2-35
SPEC