Installing The Handlebar - Yamaha 2002 TDM900 Service Manual

HANDLEBAR
EAS00670

INSTALLING THE HANDLEBAR

1. Stand the motorcycle on a level surface.
WARNING
Securely support the motorcycle so that
there is no danger of it falling over.
2. Install:
S handlebar 1
S upper handlebar holders 2
CAUTION:
S First, tighten the bolts on the front side of
the handlebar holder, and then on the rear
side.
S Turn the handlebar all the way to the left
and right. If there is any contact with the
fuel tank, adjust the handlebar position.
NOTE:
S The upper handlebar holders should be
installed with the arrow marks a facing for-
ward A .
S Align the match marks b on the handlebar
with the upper surface of the lower handlebar
holders.
3. Install:
S throttle grip
S throttle cable housing
S throttle cable
NOTE:
Align the projection a on the throttle cable
housing with the hole b in the handlebar.
4. Install:
S left handlebar switch
S right handlebar switch
NOTE:
Align the projections a on the handlebar
switches with the hole b in the handlebar.
4-59
CHAS
23 Nm (2.3 mSkg)