Unpacking; Removing Protective Packing Materials; Installing The Td Cartridge - Sharp AL-2020 Service Manual

4. Unpacking

Be sure to hold the handles on both sides of the unit to unpack the
unit and carry it to the installation location.
5. Removing protective packing
materials
1) Remove all pieces of tape shown in the illustration below.
Then open the SPF and remove protective materials. After
that, take out the bag containing the TD cartridge.
AL-2020
AL-2035/2040/2050/2060
2) Release the scan head locking switch.
The scan head locking switch is under the document glass.
If the switch is locked ( ), the unit will not operate. Unlock the
switch ( ) as shown below.
Grasp here and turn in
the direction of the arrow.
Lock Unlock
To lock the scan head locking switch, hold up the catch in illus-
tration (A) and turn the center knob counter-clockwise 90
degrees until you hear a click.
AL-2020
AL-2035/2040/2050/2060
(A)
AL-2020/2035/2040/2050/2060 UNPACKING AND INSTALLATION 5 - 2

6. Installing the TD cartridge

1) Open the multi-bypass tray, and then open the side cover.
2) Remove the CAUTION tape from the front cover and remove
the two protective pins from the fusing unit by pulling the
strings upward one at a time.
CAUTION tape
3) Push gently on both sides of the front cover to open the cover.
4) Remove the TD cartridge from the bag. Remove the protective
paper. Hold the cartridge on both sides and shake it horizon-
tally four or five times. Hold the tab of the protective cover and
pull the tab to your side to remove the cover.
4 or 5 times
5) Gently insert the TD cartridge until it locks in place while push-
ing the lock release button.
Lock release button
Protective pins