Enable Dhcp - HP 5920 Series Configuration Manual

Figure 113 Network diagram
Configuration procedure
1. Configure Switch A:
# Specify the IP address for Ten-GigabitEthernet 1/0/1.
<SwitchA> system-view
[SwitchA] interface ten-gigabitethernet 1/0/1
[SwitchA-Ten-GigabitEthernet1/0/1] port link-mode route
[SwitchA-Ten-GigabitEthernet1/0/1] ip address 10.1.1.1 24
[SwitchA-Ten-GigabitEthernet1/0/1] quit
# Configure DHCP.
[SwitchA] dhcp enable
[SwitchA] dhcp server ip-pool 1
[SwitchA-dhcp-pool-1] network 10.10.1.0 mask 255.255.255.0
[SwitchA-dhcp-pool-1] gateway-list 10.10.1.1
[SwitchA-dhcp-pool-1] quit
[SwitchA] ip route-static 10.10.1.0 24 10.1.1.2
2. Configure Switch B:

# Enable DHCP.

<SwitchB> system-view
[SwitchB] dhcp enable
# Specify the IP addresses of Ten-GigabitEthernet 1/0/1 and Ten-GigabitEthernet 1/0/2.
[SwitchB] interface ten-gigabitethernet 1/0/1
[SwitchB-Ten-GigabitEthernet1/0/1] port link-mode route
[SwitchB-Ten-GigabitEthernet1/0/1] ip address 10.1.1.2 24
[SwitchB-Ten-GigabitEthernet1/0/1] quit
[SwitchB] interface ten-gigabitethernet 1/0/2
[SwitchB-Ten-GigabitEthernet1/0/2] port link-mode route
[SwitchB-Ten-GigabitEthernet1/0/2] ip address 10.10.1.1 24
# Enable DHCP relay agent on Ten-GigabitEthernet 1/0/2.
[SwitchB-Ten-GigabitEthernet1/0/2] dhcp select relay
# Add the DHCP server 10.1.1.1 to DHCP server group 1.
[SwitchB-Ten-GigabitEthernet1/0/2] dhcp relay server-address 10.1.1.1
# Enable authorized ARP.
[SwitchB-Ten-GigabitEthernet1/0/2] arp authorized enable
[SwitchB-Ten-GigabitEthernet1/0/2] quit
335