HP 5920 Series Configuration Manual page 240

Step
1. Enter system view.
2. Create a manual IPsec
policy entry and enter its
view.
3. (Optional.) Configure a
description for the IPsec
policy.
4. Specify an ACL for the
IPsec policy.
5. Specify an IPsec
transform set for the IPsec
policy.
6. Specify the remote IP
address of the IPsec
tunnel.
7. Configure an SPI for the
inbound or outbound
IPsec SA.
Command
system-view
ipsec { ipv6-policy | policy }
policy-name seq-number manual
description text
security acl [ ipv6 ] { acl-number |
name acl-name }
transform-set transform-set-name
remote-address { ipv4-address |
ipv6 ipv6-address }
•
To configure an SPI for the
inbound IPsec SA:
sa spi inbound { ah | esp }
spi-number
•
To configure an SPI for the
outbound IPsec SA:
sa spi outbound { ah | esp }
spi-number
229
Remarks
N/A
By default, no IPsec policy exists.
By default, no description is configured.
By default, an IPsec policy references no
ACL.
An IPsec policy can reference only one
ACL.
By default, an IPsec policy references no
IPsec transform set.
A manual IPsec policy can reference only
one IPsec transform set.
By default, the remote IP address of the
IPsec tunnel is not specified.
The local IPv4 address of the IPsec tunnel
is the primary IPv4 address of the
interface to which the IPsec policy is
applied. The local IPv6 address of the
IPsec tunnel is the first IPv6 address of the
interface to which the IPsec policy is
applied.
By default, no SPI is configured for the
inbound or outbound IPsec SA.