HP 5920 Series Configuration Manual page 129

[Switch–Vlan-interface100] quit
Verifying the configuration
Verify that the portal configuration has taken effect.
[Switch] display portal interface vlan-interface 100
Portal information of Vlan-interface100
IPv4:
Portal status: Enabled
Authentication type: Redhcp
Portal Web server: newpt
Authentication domain: Not configured
Bas-ip: 20.20.20.1
User Detection:
Action for server detection:
Server type
--
Layer3 source network:
IP address
Destination authenticate subnet:
IP address
IPv6:
Portal status: Disabled
Authentication type: Disabled
Portal Web server: Not configured
Authentication domain: Not configured
Bas-ipv6: Not configured
User detection: Not configured
Action for server detection:
Server type
--
Layer3 source network:
IP address
Destination authenticate subnet:
IP address
A user can perform portal authentication by using the HP iNode client or through Web page. Before
passing the
http://192.168.0.1 1 1:8080/portal and all Web requests will be redirected to the authentication page.
After passing the authentication, the user can access Internet resources.
After the user passes authentication, you can use the following command to display information about
the portal user.
[Switch] display portal user interface vlan-interface 100
Total portal users: 1
Username: abc
Portal server: newpt
State: Online
Authorization ACL: None
Not configured
Server name
--
Server name
--
authentication, the
Mask
Mask
user can access
118
Action
--
Action
--
Prefix length
Prefix length
only the authentication page