Dvvk-4Re Vent Kit Installation Instructions - Empire Comfort Systems DVP42FP30N-4 Installation Instructions And Owner's Manual

DVVK-4RE VENT KIT INSTALLATION INSTRUCTIONS

NOTICE: For top vent installation only: Use of a DVA47 adap-
tor is required.
CAUTION: Sharp edges, use protective gloves when
installing.
Tools Needed for Installation:
Sheet metal snips
5/16" nut driver
High temperature sealant or furnace cement rated for continuous
o
use at 1,000 F minimum
Measuring tape
See parts list on page 36 to verify components included in this vent
kit prior to installation.
NOTICE:
DVVK4RE (top vent connection only). See Figure 59.
NOTICE:
kit should be used (sold separately, part number DV-822).
The vinyl siding vent kit, DV-822, is available from Empire Comfort
depth plus the additional 3" (76mm) depth of the vinyl siding vent
cap extension should not exceed a total depth of 13 3/4" (349mm).
6 5/8" (168mm) x 4" (102mm) rigid venting (See Fireplace Instruc-
tions for approved lengths) See Figure 59.
Installing Wall Thimble/Firestop Assembly
a 7" (178mm) diameter hole needs to be cut.
is over 5 3/8" (137mm), then the extension thimble should be
used. See Figure 58.
Page 34
Figure 58)
Cutting Vent Tubes
Figure 58). Telescope
This is the most important part of the installation. With the
nent location, the 6 5/8" (168mm) diameter air inlet tube and the 4"
5.
Figure 58
Figure 59
Attach the inlet tube to the outside mounting plate. Align
tinnerman clips on the tabs of the air inlet tube to the holes
and outside mounting plate. See Figures 60 and 61.
-
31455-10-1115