Millivolt System Operating Instructions - Empire Comfort Systems DVP42FP30N-4 Installation Instructions And Owner's Manual

MILLIVOLT SYSTEM OPERATING INSTRUCTIONS

750 Millivolt System
The standing pilot (750 millivolt system) is a continuous burning
When you ignite the pilot, the thermopile produces millivolts (electrical
seconds to 1 minute time period you can release the gas control
knob from the PILOT position to the ON position. This time period
standing pilot controls found in this manual and on labels found
in control compartment behind the door assembly.
CAUTION: During the initial purging and subsequent
lightings, never allow the gas valve control knob to remain
depressed in the "pilot" position without pushing the piezo
ignitor button at least once every second.
2. During the operating season, leave the control valve knob in
NOTICE:
3. When the operating season is over, turn the Remote/OFF/ON
Page 46
Figure 73
Initial Lighting
Upon completing the gas line or turning the gas valve on after it has
lines to purge themselves of this air. Once the purging is complete,
if the gas valve is not turned to "OFF."
Pilot Flame
The thermopile/thermocouple (standing pilot) tips should be covered
Figure 74
31455-10-1115