Initial Start Up Gas Line Purge; Direct Ignition Troubleshooting - Empire Comfort Systems DVP42FP30N-4 Installation Instructions And Owner's Manual

NOTE: UNIT MUST BE PROPERLY GROUNDED FOR ELECTRONIC IGNITION TO FUNCTION.
3. If burner does not light after spark sequence has ended, use
13 for fast reset function.
blink 4 times repetitively. Then retry for ignition.

DIRECT IGNITION TROUBLESHOOTING

problems and the corrective action to be taken.
SYMPTOM
reset cycle* has been completed
to spark for several seconds and then
indicator light).
Spark for six seconds at ignitor, but no
ignition of burner.
Spark for six seconds, main burner lights,
Main burner lights normally and then goes
out.
31455-10-1115

INITIAL START UP GAS LINE PURGE

PURGE PROCEDURE
green ground must also be secured for
proper operation.
a. Check that gas is turned on and system
purged
b. Check that tips of ignitor are directly
above ports on main burner. Spark is
electrode to burner.
c. Check for 120V at each coil on the gas
valve and listen for click, indicating gas
valve is opening.
for broken electrode on high-tension lead
attachment to module.
a. Check thermostat if applicable.
b. Check high-tension lead and connector
for shorts.
c. Refer to installation instructions
troubleshooting guide for issues such
as venting.
4 until ignition is achieved.
6. Turn burner off and install glass door frame assembly.
CHECK
If 120V not present, check fuse or circuit
check operation of the control system by
running a grounded extension cord from
reset procedure above in order to clear the
light codes.
Turn gas on and/or purge system
Position electrodes so tips are directly
above burner port ports and about ¼" to
3 /8" above burner.
If 120V present, but gas valve does not click,
replace gas valve.
and repair defective electric connections.
If all electrical connections are clean and
correct, replace module.
Turn thermostat up to call for heat or replace
Replace spark electrode assembly
Repair as required.
INSULATED
JUMPER WIRE
ACTION
Page 53