Rf Operating Instructions - Empire Comfort Systems DVP42FP30N-4 Installation Instructions And Owner's Manual

RF VALVE OPERATION (AF-4040 Electronic Gas Valve system
only)
Please refer to the separate instructions for detailed operation and
programming of the Multi-function Remote Control.
The AF-4040 Electronic Gas Control Valve features a Remote
pane or natural gas (pre-set at the factory).
SPECIAL FEATURES ON THE CONTROL MODULE
the system.
CONTINUOUS PILOT FEATURE:
from a spark to pilot system to a standing pilot system.
Module (#4) that reads CONTINUOUS PILOT ON/OFF. This
Note: The Continuous pilot mode setting is generally recom-
mended on Direct Vent appliances during cold climate sea-
REMOTE CONTROL FEATURE: The Control Module has a built
hand held remote transmitter.
ule that reads REMOTE/OFF.
31455-10-1115

RF OPERATING INSTRUCTIONS

2
1
Index No. Part No.
1 R10418
2 R10415
3 R2522
4 R11007
5 R10416
6 R10419
R10423
7
R10424
R11006
The Control Module must be programmed to the Remote Control.
-
1. To program, located the learn button on the left side of the
Control Module Note: Press and release the learn button.
press any key on the remote transmitter. Once the internal
and hold the learn button for 20 seconds. The module should
emit a short beep (less than 1 second) to indicate that the
beep (3 seconds).
POWER SUPPLY SYSTEM
through a 6.0 volt DC adaptor. The AC adaptor is connected to the
This control system also includes a Battery Back-up pack that al-
NOTE:
NOTE: All Batteries should be replaced at least once each year,
preferably at the beginning of the heating season.
CAUTION: Fire or explosion hazard. Can cause property dam-
-
Do not attempt to take apart the gas control or to clean it. Improper
assembly and cleaning can cause unreliable operation.
-
7
3
4
Description
Battery Back-up
AF Valve, RF
AF Control Module
AF Extension Module
AC Adapter
Pilot Assembly - Nat
Pilot Assembly - LP
Remote Control
Figure 78
6
5
Page 61