Direct Ignition Propane/Lp Gas Conversion - Empire Comfort Systems DVP42FP30N-4 Installation Instructions And Owner's Manual

DIRECT IGNITION PROPANE/LP GAS CONVERSION

The conversion shall be carried out in accordance with the
requirements of the provincial authorities having jurisdiction
and in accordance with the requirements of the CSA B149.2
installation code (Canada) and with the requirements of the
National Fuel Gas Code Z223.1/NFPA 54 (United States).
WARNING: This conversion kit shall be installed by a
instructions and all applicable codes and requirements of the
authority having jurisdiction. If the information in this
instruction is not followed exactly, a fire, explosion, or
production of carbon monoxide may result causing property
agency is responsible for the proper installation of this kit. The
installation is not proper and complete until the operation of
the converted appliance is checked as specified in the
Installer notice:
on the conversion label. Remove the backing from label and stick
Installer notice:
natural gas to propane/LP gas.
to operate on natural gas. Please see the appropriate parts list for
any items that are missing before installing the conversion kit.
1. Turn off the gas supply.
2. Turn off the electrical supply to the appliance if so equipped.
4. Remove glass frame assembly.
5. Remove logs from burner assembly.
VALVE CONVERSION
plastic cap.
main burner.
slide main burner from left to right. Be careful as you remove
main burner in order to protect the electrodes from being
damaged.
Page 54
12. Install propane/LP main burner orifice marked #54 for
DVP42FP or marked #51 for DVP48FP.
14. Replace main burner onto burner assembly. Place main
burner beneath electrodes, slide main burner from right to
you and into air shutter.
15. Set air shutter opening at 1/4" for DVD32 or DVD36 and 5/16"
main burner.
17. Refer to log placement, page 39 to place logs onto burner
assembly.
the outlet pressure tap of the control valve.
19. Turn on the gas supply. Turn on the electrical supply to the
or leak detection solution. Bubbles indicate a leak that MUST
21. Relight the main burners and verify proper burner ignition and
operation.
22. With the main burner burning, read the pressure on the
manometer or pressure gauge. The pressure on the gauge
23. Turn off the gas supply. Turn off the electrical supply to the
appliance.
in the pressure tap.
25. Turn on the gas supply. Turn on the electrical supply to the
appliance.
26. Immediately test all gas line connections and the control
gas detection solution. Bubbles indicate a leak that MUST be
28. Replace glass frame assembly.
29. Reinstall top and bottom louvers.
31455-10-1115