Intermittent Pilot Lighting Instructions - Empire Comfort Systems DVP42FP30N-4 Installation Instructions And Owner's Manual

INTERMITTENT PILOT LIGHTING INSTRUCTIONS

FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING:
causing property damage, personal injury or loss of life.
B. BEFORE LIGHTING smell all around the appliance area for
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance. Do not touch any electrical
gas supplier's instructions. If you can not reach your gas
1. STOP! Read the safety information above.
3. Remove front surround panel assembly or bottom louver if
included.
5. Wait ten minutes to clear out any gas. Then smell for gas,
the safety information above on this page. If you do not smell
gas, go to the next step.
behind the burner on the right side.
seconds, stop and go to Step 5.
performed (if applicable).
2. Gain access to control compart. Remove surround panel
assembly if necessary.
31455-10-1115
LIGHTING INSTRUCTIONS
to "On" position.
TO TURN OFF GAS TO FIREPLACE
C. Use only the remote control or manual remote receiver
vice technician. Force or attempted repair may result in a
appliance and to replace any part of the control system and
9. Refer to remote control instructions for detailed information,
control features, and operation. Note: There is a CPI/IPI
intermittent pilot mode. See appliance manual for location
service technician or gas supplier.
10. If the burner or pilot does not operate properly after several
your service technician or gas supplier.
11. Replace the front surround assembly or close bottom louver
assembly.
12. Operation of the gas valve is controlled by a manual on/
instructions for detailed operation information.
GAS COCK
"OFF". Do not force.
4. Close bottom louver assembly, if included.
-
to "OFF" and call
Page 57