Resetting The System; Default System Settings - Pioneer SC-LX73 Operating Instructions Manual

Using other functions

Resetting the system

Use this procedure to reset all the receiver's settings to
the factory default. Use the front panel controls to do this.
Set MULTI-ZONE to OFF.
• Disconnect the iPod and USB memory device from
the receiver beforehand.
1 Switch the receiver into standby.
2 While holding down ENTER on the front panel,
press  STANDBY/ON.
The display shows RESET  NO .
Select 'RESET' using PRESET /, then press
3
ENTER on the front panel.
The display shows RESET? OK.
4 Press ENTER to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
• Note that all settings will be saved, even if the
receiver is unplugged.

Default system settings

Setting
Digital Video Conversion
SPEAKERS
Speaker System
Speaker Setting Front
Center
FH/FW
Surr
SB
SW
Surround Position
Crossover
X-Curve
THX Audio Setting
DIMMER
Network Standby
Inputs
See Input function default and possible settings on page 45.
HDMI
HDMI Audio
HDMI output
Control
Control Mode
DIsplay Power Off
Setting
DSP
Power On Level
Volume Limit
Mute Level
Phase Control
Sound Retriever
Sound Delay
Dual Mono
DRC
SACD Gain
LFE Attenuate
Auto delay
Digital Safety
Effect Level
2 PL II Music
Options
Default
ON
A
Neo:6 Options
Normal (SB/FH)
SMALL
All Inputs
SMALL
SMALL
See also Setting the Audio options on page 71 for other default
SMALL
DSP settings.
SMALLx2
MCACC
YES
MCACC Position Memory
IN REAR
Channel Level (M1 to M6)
80 Hz
Speaker Distance (M1 to M6)
OFF
Standing Wave
1.2 m<
(M1 to M6)
Brightest
OFF
EQ Data (M1 to M6)
Amp
HDMI OUT ALL
ON
ALL
YES
Default
LAST
OFF
FULL
ON
iPod/USB, HOME ON
MEDIA GALLERY (SC-
LX83 only), INTERNET
RADIO (SC-LX73
only), ADAPTER
PORT function
Other functions OFF
0.0 frame
CH1
AUTO
0 dB
0 dB
OFF
OFF
ExtendedStereo 90
Other modes 50
Center Width 3
Dimension 0
Panorama OFF
Center Image Neo:6 MUSIC: 3
Neo:6 CINEMA: 10
Listening Mode AUTO
(2 ch/multi ch) SURROUND
Listening Mode (HP) STEREO
M1: MEMORY 1
0.0 dB
3.00 m
ATT of all channels/ 0.0 dB
filters
SWch Wide Trim 0.0 dB
All channels/bands 0.0 dB
EQ Wide Trim 0.0 dB
09
77
En