Playing A Usb Device; Playing Back Audio Files Stored On A Usb Memory Device - Pioneer SC-LX73 Operating Instructions Manual

05 Basic playback
Switching the iPod controls
You can switch over the iPod controls between the iPod
and the receiver.
1 Press iPod CTRL to switch the iPod controls.
This enables operation and display on your iPod, and this
receiver's remote control and GUI screen become
inactive.
2 Press iPod CTRL again to switch back to the receiver
controls.
Note
1 You cannot use this function, when an iPod of fifth generation or iPod nano of first generation is connected.
2 • Compatible USB devices include external magnetic hard drives, portable flash memory drives (particularly key drives) and digital audio
players (MP3 players) of format FAT16/32.
• Pioneer cannot guarantee compatibility (operation and/or bus power) with all USB mass storage devices and assumes no responsibility for
any loss of data that may occur when connected to this receiver.
3 Make sure the receiver is in standby when disconnecting the USB device.
4 SC-LX73 only: The iPod/USB function cannot be selected in the main zone when the Internet radio function is selected in the sub zone. Also,
the iPod/USB function cannot be selected in the sub zone when the Internet radio function is selected in the main zone.
5 Note that non-Roman characters in the playlist are displayed as #.
48
En
1

Playing a USB device

2
It is possible to play files using the USB interface on the
front of this receiver.
1 Switch on the receiver and your TV.
See Connecting a USB device on page 38.
2 SC-LX83 only: Set the remote control operation
selector switch to SOURCE.
3 Press iPod USB on the remote control to switch the
4
receiver to the iPod/USB.
Loading appears in the GUI screen as this receiver starts
recognizing the USB device connected. When the display
shows the USB Top menu you're ready to play from the
USB device.
Important
If an Over Current message lights in the display, the
power requirements of the USB device are too high for
this receiver. Try following the points below:
• Switch the receiver off, then on again.
• Reconnect the USB device with the receiver switched
off.
• Use a dedicated AC adapter (supplied with the
device) for USB power.
If this doesn't remedy the problem, it is likely your USB
device is incompatible.
Playing back audio files stored on a USB
memory device
The maximum number of levels that you can select in
Step 2 (below) is 8. Also, you can display and play back
up to 30 000 folders and files within a USB memory
5
device.
Use / to select 'Music' from the USB Top menu.
1
Use / to select a folder, then press ENTER to
2
browse that folder.
• To return to the previous level any time, press
RETURN.
3