Using The Sleep Timer; Dimming The Display; Checking Your System Settings; Resetting The System - Pioneer VSX-922-K Operating Instructions Manual

09

Using the sleep timer

The sleep timer switches the receiver into standby after a specified amount of time so you can fall asleep without
worrying about the receiver being left on all night. Use the remote control to set the sleep timer.
% Press to the receiver operation mode, then press SLEEP repeatedly to set the sleep
time.
30 min
Off
! You can check the remaining sleep time at any time by pressing SLEEP once. Pressing repeatedly will cycle
through the sleep options again.
! The sleep timer is valid for all zones. If any zone is on, the sleep timer continues functioning.

Dimming the display

You can choose between four brightness levels for the front panel display. Note that when selecting sources, the
display automatically brightens for a few seconds.
%
Press to the receiver operation mode, then press DIMMER repeatedly to change the
brightness of the front panel display.
! You can also choose to turn the display off. In this case, the FL OFF indicator lights.

Checking your system settings

Use the status display screen to check your current settings for features such as surround back channel process-
ing and your current MCACC preset.
1 Press to the receiver operation mode, then press STATUS to check the system
settings.
The front panel display shows each of the following settings for three seconds each: Input Source d Sampling
Frequency d MCACC preset d ZONE 2 input.
2 When you're finished, press STATUS again to switch off the display.

Resetting the system

Use this procedure to reset all the receiver's settings to the factory default. Use the front panel controls to do this.
Set MULTI-ZONE to MULTI ZONE OFF.
! Disconnect the iPod and USB memory device from the receiver beforehand.
! Set the Control with HDMI to OFF (see HDMI Setup
1 Switch the receiver into standby.
2 While holding down ENTER on the front panel, press u STANDBY/ON.
The display shows RESET c NO d.
Select 'RESET' using PRESET k/l, then press ENTER on the front panel.
3
The display shows RESET? OK.
4 Press ENTER to confirm.
OK appears in the display to indicate that the receiver has been reset to the factory default settings.
! Note that all settings will be saved, even if the receiver is unplugged.
60 min
90 min
on page 53).
Default system settings
Setting
Digital Video Converter
SPEAKERS
Speaker System
Front
Center
FH/FW
Speaker Setting
Surr
SB
SW
Surround Position
Crossover
X-Curve
DIMMER
Inputs
See Input function default and possible settings on
HDMI
HDMI Audio
Control
Control Mode
ARC (Audio Return Channel)
PQLS
Standby Through
DSP
Power On Level
Volume Limit
Mute Level
Phase Control
iPod/USB, INTERNET RADIO, MEDIA
SERVER, FAVORITES, ADAPTER PORT
Auto Sound Retriever
input function
Other input functions
Sound Delay
Dual Mono
DRC
SACD Gain
LFE Attenuate
Auto delay
Digital Safety
ExtendedStereo
Effect Level
Other modes
61
Using other functions
Default
ON
SB/FH ON
Normal(SB/FH)
SMALL
SMALL
SMALL
SMALL
SMALLx2
YES
IN REAR
80 Hz
OFF
Brightest
page 34.
AMP
OFF
--- (OFF)
--- (OFF)
--- (AUTO)
OFF
LAST
OFF
FULL
ON
ON
OFF
0.0 frame
CH1
AUTO
0 dB
0 dB
OFF
OFF
90
50