Resetting The System; Default System Settings - Pioneer VSX-90 Operating Instructions Manual

10

Resetting the system

Use this procedure to reset all the receiver's settings to the factory default. Use the front panel controls to do this.
Set MULTI-ZONE to MULTI ZONE OFF.
! Disconnect the iPod and USB memory device from the receiver beforehand.
! Set the Control with HDMI to OFF (see HDMI Setup
1 Switch the receiver into standby.
2 While holding down ENTER on the front panel, press u STANDBY/ON.
The display shows RESET c NO d.
3 Select 'RESET' using PRESET k/l, then press ENTER on the front panel.
The display shows RESET? OK.
4 Press ENTER to confirm.
OK appears in the display to indicate that the receiver has been reset to the factory default settings.
! Note that all settings will be saved, even if the receiver is unplugged.

Default system settings

Setting
SPEAKERS
Speaker System
Front
Center
TMd
<a>
FW
Speaker Setting
<a>
Surr
SB
<a>
SW
Surround Position
<a>
Crossover
X-Curve
DIMMER
Inputs
See Input function default and possible settings on page 63
Input Volume Absorber All Inputs
HDMI
HDMI Audio
Control
Control Mode
ARC (Audio Return Channel)
Standby Through
4K/60pBD
4K/60pH1 (HDMI IN 1)
on page 86 ).
Default
SB/TMd ON<a>/ON<b>
7.2ch/5.2.2ch<a>/5.2ch<b>
SMALL
SMALL
SMALL
SMALL
SMALL
SMALLx2
YES
ON SIDE
80Hz
OFF
Brightest
.
0dB
AMP
OFF
--- (OFF)
--- (OFF)
OFF
4:2:0
4:2:0
Setting
4K/60pH2 (HDMI IN 2)
DSP
Power On Level
Volume Limit
Mute Level
Phase Control
Auto Sound Retriever
Sound Delay
Dual Mono
DRC
LFE Attenuate
Auto delay
Digital Safety
Effect Level ALC (Auto Level Control)
Center Spread
<a>
Center Width
PL II Music Options
Dimension
<b>
Panorama
Neo:6 Options Center Image
Listening Mode (2 ch/multi ch)
All Inputs
Listening Mode (Headphones)
See also Setting the Audio options on page 89 for other default DSP settings.
MCACC
MCACC Position Memory
Channel Level (M1 to M6)
Speaker Distance (M1 to M6)
ATT of all channels/filters
Standing Wave (M1 to M6)
SWch Wide Trim
All channels/bands
EQ Data (M1 to M6)
EQ Wide Trim
Network
Network Standby
DHCP
a VSX-90 only.
b VSX-45 only.
95
Using other functions
Default
4:2:0
LAST
OFF
FULL
ON
OFF
0 ms
CH1
OFF
0dB
OFF
OFF
50
OFF
3
0
OFF
Neo:6 CINEMA: 10
Neo:6 MUSIC: 3
AUTO SURROUND
STEREO
M1. MEMORY 1
0.0 dB
10'00''
0.0 dB
0.0 dB
0.0 dB
0.0 dB
ON
ON