Pfaff 3568-12/22 Instruction Manual page 32

Mounting and commissioning the machine
9 - 5
Fig. 9 - 06
Insert adjustment pin 2 into the hole in the X/Y control. Move X/Y carriage with the
number keys "4", "6", "2" and "8" in such a way that the end of adjustment pin 2 falls
easily into the back hole of the zero point gauge 1. (see Fig. 9-06).
Remove adjustment pin 2.
Press Enter.
Display: "SERVICE
Select MANUAL mode to bring the X/Y control to home position.
Press transport arm/sewing jig to swing the transport arm to the sewing station.
Press home position key twice.
Insert adjustment pin 2 into the hole in the X/Y control (see Fig. 9-07).
The end of the adjustment pin 2 must now easily fall into the front hole of the zero point
gauge 1. If this is not the case, the switch vanes of the X/Y carriage must be adjusted
(see chapter 13.08.01 Adjusting the switch vanes on the X/Y control).
Remove zero point jig 1.
2
Fig. 9 - 07
2
1
#800"