Table of Contents
Advertisement
Hardware Preparation and Installation
Installing the MVME712-13 and MVME712AM as a Modem
To install the MVME712-13 and MVME712AM with serial port 2 configured as
a modem, which is the as-shipped configuration, proceed as described in this
2
section. See also
N
ote
1.
Install the LCP2 adapter module to the backplane directly in line with the
P2 connector on the MVME1xx VMEmodule. Be sure to orient pin 1 of the
adapter with pin 1 of the backplane connector.
2.
Verify that serial port 2 is conÞgured as a modem port (refer to the Serial
Port 2 Configuration paragraph).
3.
MVME712-13: Attach the cable supplied with the MVME712-13 module
from LCP2 adapter connector J2 to connector P2 on the MVME712-13
module. Be sure to orient cable pin 1 with connector pin 1. See
MVME712AM: Attach the cable supplied with the MVME712AM module
from LCP2 adapter connector J2 to connector J11 on the MVME712AM
module. Be sure to orient cable pin 1 with connector pin 1. See
4.
Connect a user-supplied cable from connector J2 on the MVME712-13 or
MVME712AM to backplane connections for +5, +12, and -12 Vdc for
modem power.
5.
Insert the MVME712-13 or MVME712AM module into the selected slot
and tighten the attaching screws.
6.
After making sure you will not pinch cables with the cover, reinstall the
cover you previously removed.
7.
Connect a user-supplied Telco modular cable to the Telco modular jack on
the front panel.
8.
Connect the power cable to the AC power source and turn on the unit.
2-14
MVME712-12/-13/A/AM/B Transition Modules and LCP2 Adapter Board UserÕs Manual
Figure 2-8
.
If you have connected your module for use with internal
SCSI devices, you may already have performed some of
these steps.
Figure 2-8
.
Figure 2-8
.
Advertisement
Table of Contents
