Travis Industries 36 CF Nstallation Manual page 49

Finalizing the Installation
4 Switch the pilot hood to the "LP" size following the directions below.
Un-screw the pilot
hood 1/4 turn.
5 Disconnect the burner tray and place it on the firebox floor (see Figure 35).
The gas control valve
and receiver module
are found on the back
side of this plate.
© Travis Industries
Slide this silver tab out.
NOTE: The sliding portion of the pilot orifice may be positioned differently. Instead
of pulling it towards you, you may push it away. Either way - when the hole appears
near the tab, the orifice is in the LP position.
(for qualified installers only)
When in the LP position a hole
will appear near one of the tabs.
4060623
49
Tighten the pilot hood
until it is fully secure.
Figure 34
The burner tray is held
in place with 7 screws.
Remove the burner tray
and place it on the
firebox floor.
Figure 35
100-01170