Remote Synchronization; Installation (Continued) - Travis Industries 36 CF Nstallation Manual

Remote Synchronization

The fireplace is shipped with the remote and wall switch pre-synchronized with the receiver module
on the fireplace. The wall switch and remote have unique codes that allow them to communicate
independently with the receiver module on the fireplace.
Testing the Remote and Wireless Wall Switch for Synchronization
NOTE: The battery box, remote, and wall switch must have batteries to complete this process.
a Shut the gas off to the appliance.
b Press the "ON" button on the remote.
Press the "ON" button on
d
the wall switch.
* If either the remote or wall switch do not work properly, follow the steps to Synchronize the
remote and wall switch on the following page.
© Travis Industries
Installation
(for qualified installers only)
The spark electrode on the pilot
assembly will start to spark*.
The spark electrode on the pilot
assembly will start to spark*.
4060623
Press the "OFF" button
c
on the remote.
Press the "OFF" button
e
on the wall switch.
Figure 16
100-01170
21